Description
TACKSOL IS 56M2 is a solvent based, pressure sensitive adhesive with very high peel adhesion. It has a very high total solids content with a relatively low viscosity.
Application
TACKSOL IS 56M2 can be applied on any substrate (paper, polyester, PP, PE, PVC). Suggested uses: when high shear at room temperature and high adhesivity and heat resistance are required.
Technical Specifications
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 1 | Total Solids | % | 58±2 |
| 3 | Brookfield Viscosity 25°C | mPa.s | 5,000 - 15,0001 |
| Solvents | toluene / isopropyl alcohol | ||
| Notes | |||
| 1 | N. 5 RV; 20 RPM | ||
Film properties
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 11 | Peel Adhesion on Steel | g/in | 1,800 - 2,800 |
| 22 | Static Shear | h | > 200 |
| 96 | S.A.F.T.1 | °C | 90 |
| 97 | Loop Tack Test | g | 2,300 |
| Notes | |||
| 1 | based on ASTM D4498-00 | ||
| Average values; 22±2 g/m² of dry adhesive on PET film 36 µm | |||
Handling
TACKSOL IS 56M2 can be coated with rotating knife or knife-over-roll.
Primerisation with specific primers is suggested when a higher adhesion to plastic films is needed (please see ICHEMCO Primer catalogue).
The product can be added with pigment masterbatches for rubber adhesives.
Packaging
The product is supplied in iron drums (145 kg).
Storing
Product must be stored in a ventilated and dry place. Avoid flames presence.
Use within 9 months from production date (unopened and in the original packaging).
Notes
The product, once coated, is subject to oxidation from air and light and must be protected in order not to compromise its performance.
| Mod. DT3002E | Creation date: 3/26/2001 | Revision: 6 | Revision date: 8 Jun 2022 |
Above information is reliable, but does not constitute warranty.
