Order this product
|
Printable version (PDF)
Order this product |
Technical data sheet |
| Tackwhite AR 11 |
Description
TACKWHITE AR 11 is a removable p.s. adhesive, based on 100% acrylic polymers in water dispersion, properly modified with additives and wetting agents which produce a very good tack and wettability of any surface combined with a very consistent removability.
Application
Suitable application is direct coating. However good results can be obtained also by transfer coating with one of following systems:
- Meyer bar, viscosity 500/1.500 cps
- Reverse roll, 5.000/8.000 cps
- Rotating knife, over 12.000 cps
Technical Specifications
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 1 | Total Solids | % | 50±2 |
| 3 | Brookfield Viscosity 25°C | cps | 500 - 1,5001 |
| 8 | pH | pH | 6.5 - 8.5 |
| Solvents | water | ||
| Notes | |||
| 1 | N. 2 RV; 20 RPM | ||
Film properties
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 11 | Peel Adhesion on Steel | g/in | 30 |
| 17 | Rolling Ball Tack | cm | 5 |
| 22 | Holding Power of Pressure Sensitive Tapes | h | not applicable |
Handling
TACKWHITE AR 11 allows the production of removable and replaceable paper labels and stickers (adhesivity will be similar to "post-it" adhesives).
Advised quantity: 15-25 g dry/sqm, according to paper porosity.
If it is coated on plastic film, usual quantity applied should be approx. 10 g dry/sqm.
Packing
TACKWHITE AR 11 is supplied in 1.000 kg tank containers or 200 kg drums.
Storing
TACKWHITE AR 11 must be stored at temperature between +5°C and +40°C, avoiding freezing conditions.