Order this product
|
Printable version (PDF)
Order this product |
Technical data sheet |
| Tacksol 10/89 HS |
Description
TACKSOL 10/89 HS is a solvent pressure sensitive adhesive, based on natural rubber and special resins. After curing, it develops a very good resistance to ageing and heat.
Application
TACKSOL 10/89 HS can be applied on any substrate (paper, polyester, PP, PE, PVC,...).
If TACKSOL 10/89 HS is applied on PVC, it is necessary to use a suitable primer, whereas it can be applied directly on other substrates.
This product is suggested for the production of protective films and tapes with high adhesion to rough surfaces.
Technical Specifications
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 1 | Total Solids | % | 30±1 |
| 3 | Brookfield Viscosity 25°C | cps | 5,000 - 10,0001 |
| Solvents | hexane | ||
| Notes | |||
| 1 | No 4 RV; 20 RPM | ||
Film properties
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 11 | Peel Adhesion on Steel | g/in | 1,300 |
| 17 | Rolling Ball Tack | cm | 2 |
| 22 | Holding Power of Pressure Sensitive Tapes | h | > 100 |
Handling
TACKSOL 10/89 HS can be diluted with aliphatic and aromatic solvents to obtain the correct viscosity.
For protective tapes it is necessary to cure the product with CURING AGENT D (0,5 - 1%), remembering that pot-life of the adhesive is reduced to 6 - 24 hours.
Packing
TACKSOL 10/89 HS is supplied in 200 litres (about 140 kg net) iron drums.
Storing
Shelf life is 6 months.