Order this product
|
Printable version (PDF)
Order this product |
Technical data sheet |
| Tacksol NIS 12 |
Description
TACKSOL NIS 12 is a solvent based pressure sensitive adhesive, formulated with different rubbers and special resins, with very high peel adhesion values.
Application
TACKSOL NIS 12 can be applied on any substrate (textile, non-woven, paper, polyester, PP, PE, PVC). It is suggested when high adhesivity and adhesion, but moderate cohesion are required (e.g. double-sided films for moquettes).
Technical Specifications
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 1 | Total Solids | % | 35±2 |
| 3 | Brookfield Viscosity 25°C | mPa.s | 4,000 - 10,0001 |
| Solvents | toluene | ||
| Notes | |||
| 1 | No 4 RV; 20 RPM | ||
Film properties
| Method of analysis | MU | Standard | |
|---|---|---|---|
| 11 | Peel Adhesion on Steel | g/in | 1,800 - 2,200 |
| 17 | Rolling Ball Tack | cm | 1 - 3 |
| 22 | Holding Power of Pressure Sensitive Tapes | h | > 10 |
Handling
TACKSOL NIS 12 can be coated with rotating knife or knife-over-roll.
Primerisation with specific primers is suggested when a higher adhesion to plastic films is needed (please see ICHEMCO catalogue).
When heat or mechanical resistance must be increased, CURING AGENT D (0.5-0.6%) should be added. In this case pot-life of the adhesive is reduced to a maximum of 24 hours.
Packing
TACKSOL NIS 12 is supplied in 200 l iron drums (about 150 Kg net).
Storing
Product must be stored in a ventilated and dry place. Avoid flames presence.
Shelf life is 6 months.